Board bring up using pre-built images

This page will cover how to bring up the ZCU102, ZC702/706, and ZedBoard using the Zynq pre-built release images

Table of Contents


Prerequisites

  1. You should have a SD card with a valid boot partition. Refer this article to set up your SD card.

ZCU102

Make sure SW6 configuration is as shown in the image:
switch configuration for SD boot


For ZCU102, you will need to copy the below files on to your SD card boot partition:
  1. BOOT.BIN
  2. image.ub
  3. boot.scr

ZC702/ZC706

Make sure SW16 configuration is as shown in the image:
switch configuration for SD boot

For ZC702/ZC706, you will need to copy below files on to your SD card boot partition:
  1. BOOT.BIN
  2. image.ub
  3. boot.scr

ZedBoard

Make sure JP 7, 8, 9, 10, and 11 configuration is as shown in the image:
For ZedBoard, you will need to copy below files on to your SD card boot partition:

  1. BOOT.BIN
  2. image.ub
  3. boot.scr

Related Links

© Copyright 2019 - 2022 Xilinx Inc. Privacy Policy